Speed Queen 28800P Washer Idler Pulley Wheel
More Information:
This Part Fits the Following Models
143 models:
28800|WP28800
Step 2: The suitable screwdriver (such as a Phillips head or a flat head screwdriver) should be employed to detach the back cover and the top cover of your washer. These should be stored securely in a location where they will not be disturbed during the repair process.
Step 3: After the covers are taken off, the idler pulley wheel should be pinpointed. It is typically located towards the center of the washer, secured to a bracket. The correctly sized wrench should be utilized to loosen the nut securing the pulley wheel. Once the nut is loosened, the old pulley wheel should be gently extracted from its position.
Step 4: The replacement pulley wheel should be taken and secured to the bracket using the same nut that was used for the previous pulley. The nut should be ensured tightened firmly, but not excessively, to prevent it from loosening again.
Step 5: After the pulley is secured, the covers of the washer can be reinstalled. The panels should be aligned correctly and fastened in place with the screws that were removed earlier.
Step 6: The power should be reconnected to the washer, it should be plugged back into the outlet, and a test run should be conducted. If it operates correctly without any issues, then the replacement is complete.
By adhering to these straightforward steps, the 28800P Speed Queen / Alliance Washer Idler Pulley Wheel should have been successfully swapped.
Please remember, these instructions serve as general guidance and should always be utilized alongside the manufacturer's manual, if available.
Customer Reviews
No reviews yet. Be the first to write one!