Speed Queen 766P3A Washer Hub And Lip Seal Kit
More Information:
This Part Fits the Following Models
154 models:
766P3|200512
Step 2: The top panel should be taken off by removing the screws found at the rear of the washer.
Step 3: The hub and seal should be identified positioned between the drive shaft and the inner basket.
Step 4: The flathead screwdriver should be employed to detach the electric wires linked to the motor.
Step 5: With the socket wrench and socket set, the hub and seal should be gently unscrewed from the washer.
Step 6: If the hub and seal seem to be stuck, the vice grips should be utilized to assist in loosening them.
Step 7: After the hub and seal have been taken out, the white lithium grease should be applied to lubricate the new hub and seal prior to installation.
Step 8: The hub and seal should be installed by tightening the bolts and screws securely.
Step 9: The wires should be reattached to the motor.
Step 10: The top panel should be reinstalled and the power cord should be reconnected to the wall socket.
Your replacement of the Speed Queen Hub and Seal Kit is now finished! By following these straightforward DIY instructions, the 766P3A Speed Queen Hub and Seal Kit can be efficiently replaced in a short time.
Please remember that these instructions are intended for general guidance and should always be utilized alongside the manufacturer's manual, if one is available.
Customer Reviews
Write a Review
-
Leak Prevention
The seal kit keeps water contained, it protects the surrounding area from spills.
-
Quick Fix
The water retention problem was fully resolved after using this hub.
-
Smooth Rotation
Prevents inner tub from shifting during spin cycles.
-
Stable Spin Balance
The washer drum seems tighter and spins evenly again.
-
Fits Perfectly
Washer regained strong spin power without slippage.