Whirlpool W11391715 Microwave Grease Filter

Step 1: Your refrigerator should be disconnected from the power source for safety before proceeding.

Step 2: The filter compartment should be located, which may be positioned in the lower grille or at the back of your fridge, depending on your specific model. To access the compartment, the button on the compartment door should be slid to the side.

Step 3: After the compartment is opened, the existing filter should be identified and taken out. A twist-off cap might be featured on the filter to facilitate removal.

Step 4: The new Whirlpool W11391715 FILTER should be grabbed and placed into the compartment. If needed, the filter should be twisted to ensure it is firmly in place.

Step 5: The filter compartment should be securely closed and the button should be pushed firmly to confirm it is locked.

Step 6: The water supply should be restored at the shut-off valve, which can be found either behind the fridge or under the sink.

Step 7: Whirlpool's website should be navigated to register your new filter and activate the six-month filter change reminder if available.

Step 8: Water should be dispensed from your dispenser for 2-3 minutes to eliminate any air trapped in the line.

Your Whirlpool W11391715 FILTER is now installed and prepared to provide you with clean and safe drinking water. Remember that your filter should be changed every 6 months to maintain optimal performance.

Please note that these instructions are served as general guidance and should be used alongside the manufacturer's manual, if accessible.

Customer Reviews

No reviews yet. Be the first to write one!

Write a Review