General Electric WE16M15 Dryer Blower Wheel E04
More Information:
This Part Fits the Following Models
769 models:
WE16X17|WE16X27|WE16X30|WE16X17|WE16X0017|WE16X0027|WE16X0030
Step 2: The screws that hold the dryer’s back panel in position should be taken off. After the screws are removed, the back panel should be elevated and detached.
Step 3: The blower wheel located at the bottom of the dryer should be identified. A small fan with fins around its edges should be visible.
Step 4: The clamp that secures the blower wheel should be loosened. For certain models, a flathead or Phillips head screwdriver may be necessary.
Step 5: The old blower wheel should be extracted from the dryer and the new blower wheel should be installed using the screwdriver.
Step 6: The clamp should be reattached and it should be verified that the blower wheel is firmly positioned.
Step 7: The screws that were previously taken out should be reinserted and the dryer’s back panel should be fastened.
Step 8: The dryer should be reconnected to the power source and the functionality of the repaired appliance should be checked.
It is important to note that these instructions serve as general guidance and should always be utilized alongside the manufacturer’s manual, if it is available.
Customer Reviews
No reviews yet. Be the first to write one!