General Electric WE25M40 Dryer Bearing Kit
More Information:
This Part Fits the Following Models
1155 modelsStep 2: The screws securing the rear panel should be taken out. The panel should be detached to reach the bearing plate.
Step 3: The motor wiring harness should be disconnected from the control assembly and the screws fastening the bearing plate should be taken out.
Step 4: The faulty bearing plate should be extracted and a new WE25M40 GE Rear Bearing Kit should be installed in its place.
Step 5: The holes in the bearing plate should be positioned to align with the support bracket and the screws should be fastened.
Step 6: The motor wiring harness should be reconnected to the control assembly.
Step 7: The rear panel should be reattached and secured using the screws.
Step 8: The power cord should be reconnected to the electrical outlet or the circuit breaker should be switched back on.
It is important to note that these instructions serve as general guidance and should always be utilized alongside the manufacturer's manual, if one is accessible.
Customer Reviews
No reviews yet. Be the first to write one!