General Electric WR50X10108 Refrigerator Freezer Defrost Thermostat
More Information:
This Part Fits the Following Models
160 models:
WR50X10109
Step 2: Locate the Defrost Thermostat - The thermostat is situated directly behind the temperature control located on the lower-right side of the refrigerator's food compartment.
Step 3: Remove the Old Defrost Thermostat - The old thermostat is to be carefully detached from the wall. It is secured with two screws. These screws are to be removed and the thermostat is to be gently pulled away from the wall.
Step 4: Remove the Wire Connectors - Two wire connectors are featured by the defrost thermostat and are attached to it. These are to be disconnected from the old thermostat and set aside.
Step 5: Install the New Defrost Thermostat - The new WR50X10108 GE refrigerator defrost thermostat is to be taken and the screws are to be aligned with the holes in the wall. It is to be gently pressed into position and the two screws are to be tightened.
Step 6: Reconnect the Wire Connectors - The two wire connectors are to be taken and attached to the new thermostat. It is to be ensured that they are pushed firmly onto the terminals to secure them.
Step 7: Test the Unit - After the new thermostat has been installed and the wires have been reconnected, the power may be turned back on to the appliance. A full cycle is to be completed by the refrigerator and it is to be verified that everything is functioning correctly.
Step 8: Clean Up - Once the installation is finished, a moment is to be taken to tidy up any mess created during the thermostat replacement. The area is to be vacuumed or swept and a final check is to be performed to ensure everything is in its designated place.
Please remember, these instructions are to serve as general guidance and should always be utilized alongside the manufacturer's manual, if available.
Customer Reviews
No reviews yet. Be the first to write one!